ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   Old's Cool (http://www.advrider.com/forums/forumdisplay.php?f=35)
-   -   all balls bearing question (http://www.advrider.com/forums/showthread.php?t=818385)

bigmd 08-17-2012 02:38 PM

all balls bearing question
 
hey guys working on an 82 cb450 project.I ordered new steering head bearings and installed.it seems the top bearing race is fully bottomed out into the recess of the head tube but does not sit flush therefore i have no room for the nut that requires the spanner wrench.is this normal.i double checked and the package def states its for my bike,.i even cross referenced on the all bals site and its the correct part number.

baloneyskin daddy 08-17-2012 02:49 PM

You should always compare aftermarket parts to the originals, or any parts for that matter, before installing them because now its too late. Are you sure the bottom race is seated properly in the frame and on the steering stem?

bigmd 08-17-2012 03:28 PM

yeah definately rushed it/\.but i double checked and bottom race was not seated.i tapped it in and buttoned it up but now the bottom tree was hitting the head tube,is it safe to say i need a washer on the bottom before the bearing?

pennswoodsed 08-17-2012 05:21 PM

Sources
 
Hi,
Maybe check with supplier or Ohio Cafe Racers .
Luck,Ed

bigmd 08-17-2012 06:12 PM

Reread directions and it says washed may be needed

concours 09-17-2012 05:26 PM

All Balls misapplied the bearings for my vintage project, TX750. Chinese bearings at upscale prices.

anonny 09-17-2012 07:57 PM

Mine (for a cl 450) came with 2 washers, a thick and a thin. I used the thin on the bottom and the thick in my bolt bin. :D


Times are GMT -7.   It's 05:25 PM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014