ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 12 of 12
Search took 0.00 seconds.
Search: Posts Made By: Noel73
Forum: Thumpers 06-27-2014, 06:05 PM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
float level

Thanks, ill shoot for 8mm on the fuel level then, the 26mm is the carb upside down from parting line of bowl to bottom side of float, was told by someone that 26-28mm was a starting point. little...
Forum: Thumpers 06-26-2014, 11:32 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
I just found out how critical float level is

I just pulled the carb on my 89 and set my initial float setting from 27 to 26 mm and it made all the difference, started on one kick cold with no sputtering or kicking back, choke system actually...
Forum: Thumpers 06-12-2014, 10:44 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
89 xt600 (43f) just above idle stumble

I went out to start her up today, full choke takes usually about 4 kicks and a little throttle to keep it running until it warms up for 30 sec. or so, I always blame ethanol for this problem because...
Forum: Central From Da Nort Woods to the Plane States 03-17-2014, 10:25 AM
Replies: 99
Views: 7,739
Posted By Noel73
Way up north here, Seneca county near green...

Way up north here, Seneca county near green springs. All flat up here nothing but pavement, a gravel road is few and far between up here. I ride an 89 xt 600 that I'm about 6 inches too short to ride...
Forum: Thumpers 03-14-2014, 10:24 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
putting in new oil check valve

Hello everyone, I will be pulling the clutch cover and replacing the oil check valve assembly on my 89 xt600 with 14000 on it. I'm going to order a new counter balancer lock washer and check out the...
Forum: Thumpers 12-28-2012, 11:01 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
Putting sintered brake pads on the front of my 89 xt?

Hello everone its time for a new set of pads on my xt and was wondering if anyone is running sintered pads? Or will that wear my rotor out early? Because parts-n-more has the sintered pads for my 89...
Forum: Old's Cool 09-03-2012, 08:06 PM
Replies: 34
Views: 8,931
Posted By Noel73
great idea

Wow, never thought of a CX as an adventure bike. I see them quite often on CL for decent prices, have been thinking about getting one. They look pretty stout, engine case looks nice and strong.
Forum: Thumpers 07-30-2012, 07:59 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
xt hard starting

mine sometimes does not want to start when hot if i try to start it too soon like going into the store or something. just puts a few times and dies out, when it does that i just give it some gas...
Forum: Thumpers 06-16-2012, 06:39 PM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
shinko 705 tire pressure on my 89 xt 600

Hello everyone, just looking to see what pressure everyone is running these tires at. I got them at the standard 22psi front and rear and they feel kind of squishy and squirrely, especially the...
Forum: Thumpers 06-11-2012, 05:56 PM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
Just got my 89 xt going too

hey got an 89 here that I just got going after 13 yrs. sitting. I had to clean the float needle seat with pointed piece of dowel rod spun in a drill, if the rubber on thje needle is still in good...
Forum: Thumpers 06-05-2012, 02:23 PM
Replies: 21
Views: 2,810
Posted By Noel73
Shinko 705

Just put a set of 705's on my xt600, front almost did it by hand. but the back tire was pretty rough to get on that last little bit. Had the bead buried into the well and tons of soapy water on it, I...
Forum: Thumpers 05-08-2012, 08:16 AM
Replies: 5,548
Views: 1,125,055
Posted By Noel73
One last problem to figure out on my xt600

Hello eveyone, getting my 89 xt600 going after it sitting for 13 years in the garage, and I think I got almost all the problems worked out except for one. It runs great after it warms up for a minute...
Showing results 1 to 12 of 12

 
Forum Jump

Times are GMT -7.   It's 10:35 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014