ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: RAZ1
Forum: Airheads 10-15-2014, 04:25 AM
Replies: 29
Views: 988
Posted By RAZ1
Parts are available - cheap, not

BMW dealer. The fairing itself (P/N 46 63 1 233 732) lists at $378 and change.

You'll also need a windshield, fittings and other necessary hardware (BTW, you'll need the long turn signal brackets...
Forum: Airheads 10-04-2014, 08:07 AM
Replies: 11
Views: 488
Posted By RAZ1
copper foil for stained glass

Copper foil for stained glass can be used for repair.
Forum: Airheads 09-07-2014, 08:45 AM
Replies: 8
Views: 734
Posted By RAZ1
All parts (except 4) are NEW and sourced from...

All parts (except 4) are NEW and sourced from BMW. That means original in my book.

Of course, Max used available parts, which means green-faced instruments (and neither voltmeter nor clock, since...
Forum: Airheads 09-05-2014, 03:23 PM
Replies: 17
Views: 865
Posted By RAZ1
Did you read this:...

Did you read this: http://bmwmotorcycletech.info/flywheelremovalwarning.htm??

There are 2 thrust washers, one of them can only be seen from the inside. Since you have the cylinders off, you should...
Forum: Airheads 09-05-2014, 01:51 PM
Replies: 72
Views: 6,129
Posted By RAZ1
The round-knobbed key was standard on /6s, ie....

The round-knobbed key was standard on /6s, ie. from 74 to 76 model-year.

It was then replaced by a folding key because the non-folding one (the round one) would break when the fork was turned with...
Forum: GS Boxers 09-05-2014, 11:58 AM
Replies: 6
Views: 581
Posted By RAZ1
Of course, sorry, brain fart.

Of course, sorry, brain fart.
Forum: GS Boxers 09-04-2014, 06:06 PM
Replies: 6
Views: 581
Posted By RAZ1
Thanks, rvt. Where the Air Temp connector...

Thanks, rvt.

Where the Air Temp connector located, and what does it look like?
Forum: GS Boxers 09-04-2014, 08:09 AM
Replies: 6
Views: 581
Posted By RAZ1
Question Hard-start 1150GS

The subject is a twoi-spark R1150GS, which has become very difficult to start after a clutch change.

Starting it takes several minutes (the starter does crank), and numerous tries.

When warm,...
Forum: Airheads 09-04-2014, 08:02 AM
Replies: 31
Views: 2,196
Posted By RAZ1
There is/was a special torque wrench, or maybe...

There is/was a special torque wrench, or maybe more accurately torque screwdriver, but the shop manual required every cable and such to be disconnected.

I tighten them it by feel.
Forum: Airheads 09-04-2014, 07:58 AM
Replies: 11
Views: 754
Posted By RAZ1
I know. It does not answer my question, since it...

I know. It does not answer my question, since it does not mention dual-seal bearings.
Forum: Airheads 09-03-2014, 02:25 PM
Replies: 11
Views: 754
Posted By RAZ1
2 P/Ns

Thanks to both of you.

There are 2 P/Ns for these 4 bearings: 23 12 1 231 495, which goes at the rear ends of the input and output shafts, and 23 12 1 233 808 which goes at both ends of the...
Forum: Airheads 09-03-2014, 09:59 AM
Replies: 11
Views: 754
Posted By RAZ1
Question Airhead transmission bearing question

Apologies if this was covered before, I could not find anything.

Subject is a 1977 gearbox.

I ordered a set of bearings from BMWBayer...
Forum: Hacks 07-09-2014, 08:11 AM
Replies: 246
Views: 22,397
Posted By RAZ1
It would be nice to find a single adaptor which...

It would be nice to find a single adaptor which would screw in the proportional valve (male tapered thread) and have a 10x1 female section for the banjo bolt.

:huh
Forum: The Garage 09-16-2013, 04:14 PM
Replies: 4,318
Views: 584,124
Posted By RAZ1
What I know about welding is just enough to not...

What I know about welding is just enough to not try it myself.

I need an attachment pin re-welded on an oilhead muffler. The pin and its bracket appear to be stainless steel. The friend I rely on...
Forum: Hacks 03-08-2013, 03:50 PM
Replies: 17
Views: 3,101
Posted By RAZ1
Laugh Because what counts is the TOTAL...

Because what counts is the TOTAL demultiplication, which is made up of the gearbox selected ratio and of the final drive gearing.

So, for example, on a 1100GS in 5th gear: 1.45 x 3 (assuming a...
Forum: Hacks 06-18-2010, 06:46 PM
Replies: 189
Views: 30,335
Posted By RAZ1
Actually, the "General" looks like a Préfet...

Actually, the "General" looks like a Préfet (Prefect) to me. IOW, he is a civilian (prefects are representatives in the provinces of the French government).

And, although Tabarly was indeed lost...
Showing results 1 to 16 of 16

 
Forum Jump

Times are GMT -7.   It's 05:46 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014