Forum: Thumpers
09-20-2012, 07:46 PM
|
|
Replies: 1,211
Views: 144,644
that would be the compression release lever...
that would be the compression release lever shaft.
it has a lever that pulls the compression release cable when you kick the bike over.
is your motor missing the lever and cable assembly?
if so,...
|
|
Forum: Thumpers
09-06-2012, 08:14 PM
|
|
Replies: 1,211
Views: 144,644
yep, all those things are on my mind.
the...
yep, all those things are on my mind.
the current mount setup is just a mock up to make sure all the holes are lined up.
the only reason things were not welded is that the welder I had up...
|
|
Forum: Thumpers
09-01-2012, 09:58 AM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
09-01-2012, 08:58 AM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-31-2012, 11:42 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-31-2012, 09:06 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-30-2012, 09:29 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-30-2012, 08:41 PM
|
|
Replies: 1,211
Views: 144,644
yeah, I know about the early 250r being air...
yeah, I know about the early 250r being air cooled, but the only one local that was reasonably priced was not one of them.
hoping it stops raining tomorrow so I can get back to work on it.
...
|
|
Forum: Thumpers
08-29-2012, 06:20 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-28-2012, 02:45 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-27-2012, 09:53 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-27-2012, 06:38 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-26-2012, 09:44 PM
|
|
Replies: 1,211
Views: 144,644
Well I picked up a bike to swap the motor into...
Well I picked up a bike to swap the motor into mine.
Its an 89 klr250. The bike is pretty ratted out, but the motor starts right up, and runs strong.
Its a kick start, four valve, water cooled...
|
|
Forum: Thumpers
08-26-2012, 11:04 AM
|
|
Replies: 1,211
Views: 144,644
Well, the bike ran.
The timing was still a...
Well, the bike ran.
The timing was still a little too advanced, but it only knocked at low engine speeds, once the rpm's were up it was good.
Still had problems though, if I ran wide open throttle...
|
|
Forum: Thumpers
08-25-2012, 09:32 PM
|
|
Replies: 1,211
Views: 144,644
well, I retarded the timing a bit.
had to...
well, I retarded the timing a bit.
had to modify the CDI trigger (because there is no adjustability built into it) by enlarging the mounting holes to allow it to slide a few degrees.
retarded the...
|
|
Forum: Thumpers
08-25-2012, 08:30 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-25-2012, 08:02 PM
|
|
Replies: 1,211
Views: 144,644
well, the new CDI came in, and I got it...
well, the new CDI came in, and I got it installed.
pretty straight forward, the CDI replaces both the CDI box, and the coil and installs in the same place as the coil.
I made a little harness...
|
|
Forum: Thumpers
08-23-2012, 09:12 PM
|
|
Replies: 1,211
Views: 144,644
I talked to my dad, who is not an electrical...
I talked to my dad, who is not an electrical engineer, but the two of us have enough understanding of many things to get ourselves into lot of trouble.
many motorcycles use common ground for both...
|
|
Forum: Thumpers
08-22-2012, 07:40 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-22-2012, 09:15 AM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-21-2012, 07:29 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-20-2012, 08:25 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-19-2012, 11:31 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-19-2012, 07:25 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-19-2012, 07:10 PM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-19-2012, 05:58 PM
|
|
Replies: 1,211
Views: 144,644
would a dying CDI still make spark?
and why...
would a dying CDI still make spark?
and why would it nor run with spark? do these motors need a really strong spark to run?
would the CDI cause issues with full throttle cut-out? or is that some...
|
|
Forum: Thumpers
08-19-2012, 01:48 PM
|
|
Replies: 1,211
Views: 144,644
good to see one more person who has all their...
good to see one more person who has all their priorities wrong :D
after the ride yesterday it became clear that the motor in my bike needs some attention, it was dying randomly, like you turned...
|
|
Forum: Thumpers
08-18-2012, 01:09 AM
|
|
Replies: 1,211
Views: 144,644
|
|
Forum: Thumpers
08-17-2012, 03:51 PM
|
|
Replies: 1,211
Views: 144,644
cool, it does not look like the eccentric has...
cool, it does not look like the eccentric has alot of adjustment built into it, I just replaced the primary chain and it is good enough for now, as cheap as the chain is I can see just replacing it...
|
|
Forum: Thumpers
08-17-2012, 08:50 AM
|
|
Replies: 1,211
Views: 144,644
the bike has since been cleaned (about thirty...
the bike has since been cleaned (about thirty seconds after the photo was taken) it just looked so good all covered in mud!
I confess that I failed to see anything about the rear swingarm bushings...
|
|
Forum: Thumpers
08-16-2012, 11:46 PM
|
|
Replies: 1,211
Views: 144,644
|
