ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 37 of 37
Search took 0.01 seconds.
Search: Posts Made By: tencrore
Forum: Thumpers 07-22-2014, 10:06 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Do you happen to have a link from where you...

Do you happen to have a link from where you purchased this fuse?

Thanks
Forum: Thumpers 05-30-2014, 10:41 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
What's the best way to turn the carb inlet? Any...

What's the best way to turn the carb inlet? Any suggestions and/or advice?

Thanks!
Forum: Thumpers 04-30-2014, 11:59 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
I just installed the Warp 9 320mm rotor as well...

I just installed the Warp 9 320mm rotor as well as Galfers stainless brake lines. If I were to do it again I would install the stainless brake lines first to see if, that alone, would have improved...
Forum: Thumpers 04-30-2014, 07:49 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Attached is a pic of where I installed the speedo...

Attached is a pic of where I installed the speedo pickup on the caliper exteder bracket from Warp 9. I drilled to additional holes on the pickup and drilled and tapped the aluminum bracket. ...
Forum: Thumpers 04-22-2014, 05:16 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Thank you Sir! Time to splice and dice.

Thank you Sir! Time to splice and dice.
Forum: Thumpers 04-22-2014, 12:02 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
High Beam Wire

I'm installing lights on the DR from ADV Monster and was hoping someone can advise what color the high beam wire is? The ADV monster switch has a blue wire that needs to be tapped into the high beam...
Forum: Thumpers 04-15-2014, 07:15 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Thanks todd900ss, Mercenary, wayno and shu for...

Thanks todd900ss, Mercenary, wayno and shu for your replies.

When I suck on the Vent Cap I can pull air through it so I'm assuming it is not causing a vacuum within the tank.

In any case, I...
Forum: Thumpers 04-14-2014, 06:40 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Fuel Tank Vent Cap Issue

So I stuck one of those Fuel Tank Vent Caps on my 5.3 gallon Acerbis tank and started the motorcycle up. The bike started up fine and then shut off after a few minutes of idling. Tried starting up...
Forum: Thumpers 04-09-2014, 05:36 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
If you're going to be doing clutch work for the...

If you're going to be doing clutch work for the DR, specifically, I'd get the EBC tool. I bought the "vise grip type" initially but the EBC tool makes it much easier.
Forum: Thumpers 03-30-2014, 11:41 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Any tutorials or links that you can direct me to...

Any tutorials or links that you can direct me to for servicing the steering head assembly?

Thank you in advance for any help.
Forum: Thumpers 03-18-2014, 11:38 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
ProCycle; Any progress on getting this exhaust to...

ProCycle; Any progress on getting this exhaust to market?!?! Really looking forward to it!
Forum: Thumpers 02-18-2014, 01:30 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Here you go; ...

Here you go;

http://www.pro-bolt.com/titanium/titanium-bolts-flanged-hex-race-spec.html?cat=722&length=193

Made by bike WAY lighter too!
Forum: Thumpers 01-23-2014, 04:46 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
I Love My DR!!

The more I ride my DR the bigger my smile gets! I've had her for about 2 months now and it's been a blast!

I took my RoadKing out last weekend, just so she'd not get too jealous, and it took...
Forum: Thumpers 01-20-2014, 06:21 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Thank you Thump and MoBill for your help!! Start...

Thank you Thump and MoBill for your help!! Start slicing and dicing tomorrow!:clap
Forum: Thumpers 01-20-2014, 11:04 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
I'm about to install the Vapor Dash on the DR and...

I'm about to install the Vapor Dash on the DR and your post raises a question; Can you please tell me where you've tapped into the coil for the RPM pickup. Looking at the wires coming from the...
Forum: Thumpers 01-18-2014, 05:24 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
CA DR650 Tank Swap

I'm almost finished with installing an Acerbis tank with a Pingel petcock on the DR. I know that I need to cap the vacuum line on the carb as I'm not using the stock petcock.

So my question has...
Forum: Thumpers 01-14-2014, 05:55 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Hello Kommando; If possible, can you suggest...

Hello Kommando;

If possible, can you suggest any link that would outline the servicing of the bearings you mention. My DR is new but I would like to be preemptive in verifying that these bearings...
Forum: Thumpers 01-09-2014, 03:55 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Cogent Rear Shock

I finally got around to installing my rear shock from Cogent!!

The hardest part was getting the darn airbox out.:fight Once that was done, it was simple as pie! The preload was set by Rick and...
Forum: Ride reports 01-09-2014, 07:02 AM
Replies: 4
Views: 659
Posted By tencrore
Looking forward to the ride! I'm visiting India...

Looking forward to the ride! I'm visiting India in July and plan on making a short trip to Rajkot, Gujarat from Bombay on my nephew's motorcycle. Accordingly, I look forward to your experiences!
Forum: Equipment 12-31-2013, 12:36 PM
Replies: 30
Views: 2,458
Posted By tencrore
For fogging issues, get the pinlock shield and...

For fogging issues, get the pinlock shield and pinlock membrane. No more fogging. Have them on my Neotec and now the Hornet!
Forum: Thumpers 12-31-2013, 10:39 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Good question! I'd like to know as well.

Good question! I'd like to know as well.
Forum: Equipment 12-30-2013, 09:39 PM
Replies: 30
Views: 2,458
Posted By tencrore
I went through the same dilemma as you are going...

I went through the same dilemma as you are going through! I wear a Shoei Neotec when I'm on my RoadKing and was interested in the Arai XD4 DS helmet along with the Hornet. In the end I went with the...
Forum: Thumpers 12-30-2013, 04:19 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Probably complete overkill but then I'd buy them...

Probably complete overkill but then I'd buy them just so that I wouldn't have to drill and break those 1/16" bits;
...
Forum: Thumpers 12-30-2013, 02:38 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
When do you except these plates will be available...

When do you except these plates will be available for sale?
Forum: Thumpers 12-29-2013, 07:52 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Brilliant!! I'm in, if you can make it fit...

Brilliant!! I'm in, if you can make it fit behind the Wolfman Gen 2 Racks!! I had to scrap my newly purchased tool tube because of the racks. They do look like it will fit but I thought I'd get my...
Forum: Thumpers 12-27-2013, 11:21 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Here's the nylon tipped set screw that I use on...

Here's the nylon tipped set screw that I use on my Ohlins shocks for my FLHR;

http://www.amazon.com/gp/product/B002CI28BM/ref=oh_details_o06_s00_i00?ie=UTF8&psc=1

Just received my front and...
Forum: Thumpers 12-20-2013, 07:38 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Vapor Install

Good Morning!

I'm about to start installing the Vapor and I tried looking for photos that show exactly where the coilover plug connection is on the DR or DR specific instructions on connecting the...
Forum: Thumpers 12-14-2013, 09:14 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Can't wait for the final product! If it's...

Can't wait for the final product! If it's anything like the other pieces I have from you, it's got to be top notch stuff! I'll be one of your first customers. :freaky
Forum: Thumpers 12-13-2013, 06:50 AM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Yes, ordered the rear shock and the DDC's. ...

Yes, ordered the rear shock and the DDC's.

Thank you for the link!. Will order to magnetic tool today.
Forum: Thumpers 12-12-2013, 05:16 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Just got a call from Joyce at Cogent letting me...

Just got a call from Joyce at Cogent letting me know my shocks are on the way!!!:clap

Any install tips that you all can give me. I've put Ohlins on my FLHR but this DS stuff is completely new to...
Forum: Thumpers 12-06-2013, 03:23 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
I'd like to convert all my lighting on my new DR...

I'd like to convert all my lighting on my new DR to LED's and an HID headlamp. Accordingly, has anyone compiled a list of the type of bulbs required for this switch or can direct me to a link? ...
Forum: Vendors 11-26-2013, 07:33 AM
Replies: 37
Views: 10,224
Posted By tencrore
Just checking in to see if the center support has...

Just checking in to see if the center support has been added?

Looking forward to getting a rack on my new DR but would like the added support of the center bolt.

Thanks
Forum: Thumpers 11-25-2013, 05:58 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Aluminum vs. Rubber Bushing in Triple Tree

So in my attempt to replace the stock bars with ProTaper Evo's and the ProTaper Universal Bar Mount I had to drill out the stock rubber bushings to accomodate the larger bolt diameter of the ProTaper...
Forum: Ride reports 11-12-2013, 04:57 PM
Replies: 393
Views: 36,092
Posted By tencrore
Great to see it can be done on an RK! I too have...

Great to see it can be done on an RK! I too have a 2008 RK! Planning my trip to Yellowknife for next year but on my newly acquired DR. Didn't feel that I could make it on the RK but you've proved...
Forum: Thumpers 11-02-2013, 08:58 PM
Replies: 96,065
Views: 18,099,549
Posted By tencrore
Hello

Couldn't find a specific 'Introduction' thread, so I thought I'd post here!

Just got back from GP Sports in San Jose from purchasing a 2013 DR650!! I pick it up Monday and cannot wait!~

I've...
Forum: Vendors 03-07-2012, 07:39 AM
Replies: 1,438
Views: 234,942
Posted By tencrore
SMH10 Ordered!

Thanks RocketMoto for the opportunity to purchase the intercom and Thanks Adam for the prompt replies to my questions!

Looking forward to using it! Will be ordering the dual set once my riding...
Forum: Road warriors 03-05-2012, 06:30 PM
Replies: 2,255
Views: 596,663
Posted By tencrore
New to this Forum and I hope to learn a lot. ...

New to this Forum and I hope to learn a lot.

My first and only bike is this 2008 Road King. Although I love my HD, my next bike is going to be a R1200 GSA!:clap
Showing results 1 to 37 of 37

 
Forum Jump

Times are GMT -7.   It's 08:22 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014