View Single Post
Old 10-27-2009, 01:34 AM   #1541
Night_Wolf
Leg Humper
 
Night_Wolf's Avatar
 
Joined: Feb 2006
Location: Lat: N 9000'00" Long: N/A
Oddometer: 8,068
Looking good so far. As for cutting out the windows with that saw, I have another way if you have a Router and are not worried about re-using the wood from the cut sections. Plunge the router into the wood where the opening is located and then pull it to the frame. Now follow the frame around and the piece will fall out. Di it from the outside obviously This is how we did it when I was builing "camps" for the oilfields

Quote:
Originally Posted by mmitchell57
Made some more progress this week. Check out the pictures.





A couple people offered to come over and help Saturday. It ended up being a blessing in disguise. They helped finish up the forth wall (w/ windows) while I went to go help mom with car problems an hour and a half out of town. By the time I got back, they had finished the wall and started measuring for the lower roof rafter. On sunday my father in law came over again around 10am and we started on sheathing and finish all we could on the roof. We sheathed over the windows and will go back and cut them out with a reciprocating saw. I still need to get a ridge board up and a roof rafter template built. I'll be going to get the framers square this week along with some other things. Let me know what you think. :)
__________________

L 51.01.900 / L W 114.05.900


"That road less traveled is a toll road, and sometimes the charge is more expensive than we ever expected. Most of the time, it's a one way road. Make the decision, hope for the best, and start traveling. Carry lots of coins." PecosBill

Pick good friends and you'll never be lacking Family Me
Night_Wolf is offline   Reply With Quote