View Single Post
Old 12-02-2009, 01:16 PM   #849
rc mad
Physycotic gecko
rc mad's Avatar
Joined: May 2006
Location: Deeping About
Oddometer: 1,486
Finally got the dogbone drawing finished

That's for a 1 inch lift, hopefully. The 20mm hole is going to have a stainless steel insert pressed into it as the stock links are wearing on the bolts at that point. These are the inserts.

Can't find any funduro lowering links so i'm going with this. There will be some filing needed when the machining is done tho
"Mad Science" means never stopping to ask "what's the worst thing that could happen?
It's Santa time folks
rc mad is offline   Reply With Quote