View Single Post
Old 12-03-2009, 02:05 AM   #850
komatias
Gnarly Adventurer
 
Joined: Jun 2005
Oddometer: 313
Thanks for sharing these... saved me alot of time.

A few comments though:

The stockers should not be wearing at the lower holes at all. When you clamp them on the lower part of the cam, you should be applying compressional force directly to the bushing through the two large cap type things. If you have wear, it is probably due to not enough torque applied to the bolt or you have shot bearings. The bolt should not move separately from the bushing.

I will also check the press fit tolerances you state. Have a feeling they are on the lower side. will report back on this.


PS:

Had a look at the tolerancing. SKF prescribe a J6 tolerance on the housing of our bearings. So that would mean the dimension would be 24mm +0.008 -0.005 which is what you got. Well done that man!

komatias screwed with this post 12-03-2009 at 03:28 AM
komatias is offline   Reply With Quote