View Single Post
Old 01-14-2010, 09:38 PM   #81
Bake OP
adventurer
 
Bake's Avatar
 
Joined: May 2005
Oddometer: 10,515
Quote:
Originally Posted by Mr. Cob
always hated working with lathes but consider myself a pretty damned good man with a mill.
Me too. Maybe it's just because I learned on them first. Most shops just had a lathe guy, and you sent your stuff to him, and made everything else yourself

Quote:
I still keep my hand in the trade working with this little old Jet bench mill, the mill was made in the early 70's and for its size if you don't push it hard it will do some decent work. Here I have it setup to mill the clearance for a V-Belt on the front cover of an experimental Ural engine.
I had an Enco in the early '80s, mill drill like that, I was perfectly happy with it. 9 x 27 travel bed, 1.5 horse 110v, worked fine.

I miss that little mill. Damn divorces.

That's quite the set-up you have going there, Dave
__________________


Bake screwed with this post 01-14-2010 at 09:44 PM
Bake is offline   Reply With Quote