View Single Post
Old 02-20-2010, 02:24 PM   #40
Chadx OP
my toot toot
Chadx's Avatar
Joined: Oct 2007
Location: Bozeman, Montana
Oddometer: 2,169
Mostly finished the handguard install today. Here is a shot before putting on the mirrors and shields.

Shot from the back. As mentioned earlier, I used custom HDB lower clamps with about 2" of rise over my stock clamps. The bar bend is 1/2" lower than stock netting me 1.5" of rise over stock.

Here it is with the shields and mirrors installed. In this photo, I've changed the handguard orientation compared to the first two photos. They are angled lower here to improve the view from the mirrors. I think they will still give me the needed protection from wind and branches. I'll adjust them to their final position once I get a few rides in. Note the clutch is out of final position in this image, as are some of the other controls. I was still tweaking positioning of everything.

Off the road again...just can't wait to get off the road again.
The life I love is making roost with my friends.

Chadx screwed with this post 04-28-2010 at 08:25 PM
Chadx is offline   Reply With Quote