View Single Post
Old 05-03-2010, 11:56 AM   #6
AngryScot OP
.
 
AngryScot's Avatar
 
Joined: Aug 2006
Location: ☼ Ca ☼
Oddometer: 18,315
Scrapped the led rear brake bulb idea, didn't know about the location, I will do the LED version (full led panel) eventually, nice to have a bright tail light in commuter traffic for sure.

Garmin GPS. Only issue is the one I caught will power off if I hit a large bump. Not a huge deal but kinda annoying, need to see if there is a easy fix for that other then wire it for power.


I seem to like to stretch out and not use the floor board too much, so I cut out some of my fav rubber diamond plate and stuck it on so it has some more grip and doesn't look so messy with all the scuffs etc on the smooth plastic.
(very klr I know!)



now to figure out the rear rack thingy since they are on back order from Japan.

Might go the welding route O'Hooligan mentioned
but I need to find a damn welder first that is local
__________________
⊕R1200GS⊕ For sale soon, snap it up and contact me.
⊕Zuma 125⊕For sale soon, snap it up and contact me.
Save $5 on Smugmug "so9RUAXlMm0bE"
AngryScot is offline   Reply With Quote