View Single Post
Old 09-07-2010, 01:17 PM   #1560
xt4ever
Adventurer
 
xt4ever's Avatar
 
Joined: Jan 2010
Location: Z, Spain
Oddometer: 80
Quote:
Originally Posted by Psycho18th
Just pull the valve cover with the engine at TDC and check the clearances with feeler gauges. If they're off, you'll have to see what shims are in there and replace each shim individually to get the correct valve clearance. Someone found the valve holding tool a few pages back, but I just pull the cams to make valve adjustments. Its only about 8 more bolts, and allows you to inspect the cams and head surface. Best investment you'd ever make is the Clymer service book for the XT. Walks you through all this stuff step by step so things don't get worse as they get removed and replaced
Psycho
I'm the guy who found the valve adjusting tool:

http://www.advrider.com/forums/showp...postcount=1338

It's a little bit expensive, but I still recomend it

HTH
-JL
xt4ever is offline   Reply With Quote