View Single Post
Old 09-19-2010, 01:12 PM   #6
LILBIT
Ride you must.
 
LILBIT's Avatar
 
Joined: Oct 2007
Location: Lake Placid, FL
Oddometer: 1,675
Quote:
Originally Posted by The Letter J
Have you considered a dampened counter shaft sprocket as a cheaper (slightly less effective? ) alternative? The splines on your counter shaft are the same as those on a 690e/r/smc which use a rubber dampened sprocket. The difference being that the 690 sprocket is slightly thicker which could be easily cut down to fit the exc. Sprockets are available in 15/16/17 tooth for around $30.

I have not personally tried this but I have put a non-dampened exc sprocket on my 690 using a small spacer behind it, so it would make sense that it could be done the other way by removing material from the inside of the sprocket.
I searched and couldn't find a picture of anything but standard. Do you have one.

Dave Hopkins claims to be doing one output shaft a week due to ruined slines from DS bikes.
__________________
I eat my candy with the pork and beans-
LILBIT is offline   Reply With Quote