View Single Post
Old 12-17-2010, 05:01 PM   #56
jdrocks OP
Gravel Runner
 
Joined: Jul 2007
Oddometer: 4,081
put the frame up on the operating table, stripped all the grommets, harness clips, and miscellaneous parts. preliminary degrease, and then marked the brackets that get cut off. they didn't put much of a paint job on the frame at the factory. anything that was not in direct view looks like it never got a finish coat.



most of the custom parts are done in steel, but these little gems were done in aluminum. if they work i own the design, but if they don't...heck, ain't never seen them things before. amazing what can be turned out for very little $.

jdrocks is online now   Reply With Quote