View Single Post
Old 04-12-2011, 11:57 AM   #6162
Alik
viertaKTMotor *****
 
Joined: Nov 2010
Location: Poznan, Poland
Oddometer: 248
A propos slave cylinder…

Here is a official mounting procedure described by Tseta in this post.

http://www.advrider.com/forums/showp...6&postcount=31
(…)
1. Mount the slave cylinder with the new clutch release gasket
(KTM part no 586.32.065.000).
2. We recommend to moisten the slave cylinder fixing screws with medium liquid screw lock compound (Loctite 243), during all kinds of service on LC 4 engines.
Important is to tighten the cylinder screws in the order – centre-bottom-top – with 8 Nm
torque. After one minute tighten the screws in this order again.
Finally, please bleed the clutch system very precise !
Alik is offline   Reply With Quote