View Single Post
Old 04-28-2011, 07:38 PM   #1486
ta2240
Adventurer
 
Joined: Oct 2003
Location: Magnolia, Texas
Oddometer: 44
Take the smallest drillbit you have and drill a small hole in the seal, then take a small fine thread wood screw and screw about two threads in the hole then pull on the screw.

Before putting the screw in I would use a shop vac to suck any shavings out of the hole, even if you cant get them out they are really soft and no damage will occur if they get past the bearing.
__________________
2007 XR650R
2007 KTM 300XC-W
2011 KTM 530 EXC
ta2240 is offline   Reply With Quote