View Single Post
Old 05-01-2011, 05:28 PM   #8
Poolside
Syndicated
 
Poolside's Avatar
 
Joined: Apr 2003
Location: Long Beach, CA
Oddometer: 11,735
There are any number of ways. Punch or drill a small hole in the the metal carrier, thread in sheet metal screws and pull.

I usually use a small dia. (maybe 2-3mm) flat faced drift, or a fresh 'sacrificial' small flat blade screwdriver, and a hammer. Use the drift or driver to smoosh in the metal carrier in a few places around the diameter. That usually loosens the friction fit between the carrier and the seal bore.

I've used this before, it worked fine too.
http://www.northernautoparts.com/Pro...tModelId=16114
http://www.google.com/search?hl=en&q...w=1024&bih=579


__________________

IICE Air Hotrod your GS  Fuel Injection  Tech Info  Buy  Order List  Installation
Poolside is offline   Reply With Quote