View Single Post
Old 10-20-2011, 11:32 AM   #25213
GSBS
FunHog
 
GSBS's Avatar
 
Joined: Nov 2005
Location: Blount Springs, AL
Oddometer: 3,885
Quote:
Originally Posted by ironbrewer View Post
I use my GPS for a speedometer and odometer. Can you in fact put your WR into permanent CO diagnostic mode to have a tach all the time? Would you just permanently ground the wire? And if you did this would you have to go through the program every time you started up the bike??
Mine's been grounded for the past 6K miles or so with no apparent ill effects. You do have to do the holding down buttons dance each time to enter the Diag Mode to access the CO settings and see the tach. It resets to whatever your last setting was each time the key is turned off.
GSBS is offline   Reply With Quote