View Single Post
Old 01-02-2012, 10:23 PM   #53
Moto Flunky
ben2go's Avatar
Joined: Jun 2011
Location: Upstate SC USA
Oddometer: 3,850
Originally Posted by pjm204 View Post
That exhaust looks damn good.

Got new bearings in the rear wheel. Sadly it appears I lost a cush drive rubber. I also cannot get these damn races out of the steering head. My cold chisel just keeps chipping apart. Trying to source a race puller I can borrow.
See if you can borrow/rent a slid hammer from and auto parts store with attachments.There is an attachment that you install on the slide hammer,then push it through the bearing race,it pivots open,and catches the back of the race.Then you just give the sliding weight a few hard jerks,and it pops out.Gotta plumbing type hand torch?A little heat above the race may loosen it.
Originally Posted by bassogap View Post
If my aunt had nuts, she'd be my uncle. What's your point?
Manic Cycles=My Blog
ben2go is offline   Reply With Quote