View Single Post
Old 01-07-2012, 07:01 PM   #57
Moto Flunky
ben2go's Avatar
Joined: Jun 2011
Location: Upstate SC USA
Oddometer: 3,850
Originally Posted by pjm204 View Post
I got the races out and the new ones in. Front end will be bolt on at this point. The issue I have is that I don't have the nuts for the stem and I don't know what stem it is to get replacements. I was told it is an Ohlins YZ450 stem, but someone else said it looked like a Pro-Taper. Dimensions for the threads are 30mm and 26mm approximately. The nuts from a YZ450 stem do not work.

Rear end is done once spacers are made...
Check with a local tool supplier.They usually know all the hardware suppliers around and can get the od sizes sometimes used on motorcycle stems.Check here and see if you have one close by.They have saved my but on many occasions.
Originally Posted by bassogap View Post
If my aunt had nuts, she'd be my uncle. What's your point?
Manic Cycles=My Blog
ben2go is offline   Reply With Quote