View Single Post
Old 01-08-2012, 07:55 AM   #58
Lampin' it
sailah's Avatar
Joined: Aug 2005
Location: Turning expensive metal into scrap
Oddometer: 5,817
Originally Posted by pjm204 View Post
I got the races out and the new ones in. Front end will be bolt on at this point. The issue I have is that I don't have the nuts for the stem and I don't know what stem it is to get replacements. I was told it is an Ohlins YZ450 stem, but someone else said it looked like a Pro-Taper. Dimensions for the threads are 30mm and 26mm approximately. The nuts from a YZ450 stem do not work.

Rear end is done once spacers are made...
Check the outside diameter and use a thread pitch guage so you know what need. I'll check my stock again to see if I have one.
We're not out here to rough it. We're here to smooth it. Things are rough enough in town.

sailah is offline   Reply With Quote