View Single Post
Old 01-12-2012, 03:48 PM   #18
marksbonneville OP
Studly Adventurer
 
marksbonneville's Avatar
 
Joined: May 2008
Location: Arizona, Prescott more less.
Oddometer: 961
Quote:
Originally Posted by motu View Post
The normal method is to smash it out with a hammer and then turn the crank back into shape on a lathe.

However I have a puller....
I wasn't about to go to work on the crank (although its already trashed), I thought the crank bearing would pop out of the case with the crank? Then I could press off the pinion gear but I don't want to damage anything.
marksbonneville is offline   Reply With Quote