View Single Post
Old 01-17-2012, 12:02 PM   #39
Pigford OP
Pigford's Avatar
Joined: Sep 2009
Location: North Dorset, UK
Oddometer: 994
Sorry chaps - not much to report

The new stem is back & I fitted it with the press at work......

I've shimmed the valves now and put the engine back in the frame to finish off the lower rear engine mounts.....

....and check the chain alignment... :?? I need to take up 30mm off-set, so want to bring the rear sprox in 10mm (to help clear the frame) and have a 20mm off-set front/drive sprox - so I'll be off to TALON again pretty soon

I've fitted a Bandit 1200 front end for the time being to get a temporary rolling chassis...

I think I'll need a chat with TALON when I collect the off-set sprox order!

Here's some close-ups of the Harrison rear caliper & the neat fitting to save having to fit a torque arm....

And heres another mock-up of the rolling chassis - Note the 4:1 ain't so nicely placed now the bulky JMC has replaced the s/s 916 s/arm

I did pick up a low mileage Wiseco 1105cc Hi-comp piston & barrel set for future use
Pigford is offline   Reply With Quote