View Single Post
Old 02-06-2012, 05:08 AM   #4
oldestbones
OldEstboNes
 
oldestbones's Avatar
 
Joined: Feb 2012
Location: Southern New Jersey
Oddometer: 2
Quote:
Originally Posted by K1W1 View Post
The original kick start had a bend in it so it cleared the outside of the footpeg. Are you sure that the original lever is fitted?
Oh ya, The clearances of the shaft to the lever where it fold out is about .015 and that makes the lever a little woobily on the shaft.
I have it cleaned up good now and am considering either having the shaft metal sprayed or using west epoxy with carbon filler to fill the void. Also need to have a little weld put on the spot where the bolt meets the lever as it appears the metal is deformed. Only needs about 2MM added to the landing area.
oldestbones is offline   Reply With Quote