I finally got the chance to throw the switch on the old stick welder - and that's usually a sign of a pretty good day. The plan is to adapt my old homemade Seahorse case rig
to the 919.
I got off to a pretty good start.
Fast forward one week:
Back to work on the side case install. I'm trying desperately to make this rig job of a rig job not look like a rig job.
The only place to hang a bracket on the 919 is the muffler mounts inside the tail plastic. Here's what I came up with.
This made replacing the tail section a little tricky.
I needed to make new rear top case supports but found myself short on material. What to do? Oh, this'll work.
ADV stickers are . . . . .O N . . . T H E . . . B I K E !