View Single Post
Old 02-27-2012, 06:25 PM   #8
Gnarly Adventurer
Joined: Dec 2011
Location: Central Pa
Oddometer: 250

In the previous pictures I was using the old axle that was too small. After a few minutes in the magic laboratory and POW the swing arm and chain adjusters accept the bigger YZ axle. Looks like the caliper will slip into place just fine. Next I will be working on the chain alignment then I can turn the spacers on the lathe. Another plus is the fact that the yz wheel feels like it must weigh 5 pounds less than the xt wheel. A lot of that could be the big ol' DOT tire too.

MILLENNIUM FALCON is offline   Reply With Quote