View Single Post
Old 03-23-2012, 11:30 PM   #2206
Billy Pilgrim
Gnarly Adventurer
 
Joined: Mar 2007
Location: Caught in the ACT, Australia
Oddometer: 178
Question Where to tap in to high beam circuit on 1200GS

I have installed a flood and spot, switch and dash light on my 07 1200GS.
I will be using a 5 pin relay as per an earlier post on this thread.
My only question is where to tap in to the high beam circuit to get the switching signal for the relay.
I'm not keen on drilling the waterproof cap behind the high beam light.

I've searched this thread using a few parameters but no luck yet.
__________________
2013 Suzuki DR650SE, 2007 BMW R1200 GS/GSA Hybrid, 2003 954 Fireblade, 2000 Sherco 2.9 Trials
Billy Pilgrim is offline   Reply With Quote