View Single Post
Old 03-24-2012, 07:20 PM   #2208
tallguy-09
Smile 4 Miles
 
tallguy-09's Avatar
 
Joined: Aug 2009
Location: Vancouver
Oddometer: 1,436
Quote:
Originally Posted by Billy Pilgrim View Post
I have installed a flood and spot, switch and dash light on my 07 1200GS.
I will be using a 5 pin relay as per an earlier post on this thread.
My only question is where to tap in to the high beam circuit to get the switching signal for the relay.
I'm not keen on drilling the waterproof cap behind the high beam light.

I've searched this thread using a few parameters but no luck yet.
No drilling required. Just tap into high beam positive wire and route thin trigger wire through vent plug, done.


tallguy-09 is offline   Reply With Quote