View Single Post
Old 03-25-2012, 12:38 PM   #110
danedg
Horizontally Opposed
 
Joined: May 2008
Location: U-puku-ipi-sing
Oddometer: 6,483
The Plan

Pull the motor/tranny
Clean the greasy dirty thing up...
Clean the dirty greasy frame up...
Powerplant
Pull heads - send to Aldo (machinist) for for testing/inspection. Repair/refresh if compression low.
Pull cylinders for Gilardoni replacement
Inspect crank/cam bearings
Replace seals front rear main
Carbs rebuilt
I don't even know yet if it's got a chain or gears but check and refresh as necessary
Improve generator mounting bracket
Replace clutch springs
Inspect plates for wear
Crack tranny/inspect for wear and replace shifter return spring
Gaskets/seals/gaskets/seals
Keep cleaning the dirty greasy bitch up
Fix whatever else looks bad

Frame/Suspenders
Clean the greasy dirty thing up
Pull rear swing, grease bearing and head yoke
Inspect repair driveshaft/UJoint/spline
Replace boot
Replace carrier
Inspect rear drive for operation
Brakes front and rear
Inspect/refresh shocks
New Cables
Check refresh harness
Keep cleaning the damn thing up
New tires
New battery
Fresh gas lines
Sparky wires
I'm gonna throw two little Uni filters on the carbs for now

Then I was gonna put fresh oil and gas in it, start it up and take it for a ride....

Did I miss anything?



danedg screwed with this post 03-25-2012 at 01:10 PM
danedg is offline   Reply With Quote