View Single Post
Old 04-13-2012, 02:51 PM   #6
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,449
It Lives....... and nicely so ....if I must say......
Idle charging went up.....


3000 rpm.......


AC ripple is about the same.... but controlled better. Recall the stock were about the same.... But then peaked at about 120 milli volt AC..... Regardless of throttle position the AC ripple was steady at 72 Milli volt AC......


I am curently working on the mount. It will mount to the stock holes.... but is to tight for my taste... But more importantly... I wanted to move it to where the Charcoal Cannister once sat..... I am also observing the rate of discharge to make sure some box is not still on since I spliced the two wires.... Perhaps someone with a diagram can chime in.... Or if we can knock Joel of the bike....... He could shine some light on this.....

Erling
ebrabaek is offline   Reply With Quote