View Single Post
Old 05-02-2012, 09:06 AM   #17604
pluric
Gimpy Adventurer
 
pluric's Avatar
 
Joined: Dec 2006
Location: Salt Lake
Oddometer: 15,917
Quote:
Originally Posted by GISkev View Post
I looked through my manual and found nothing other than the piston circlips that look anything like it. I'm curious as to if the piston comes down far enough that the circlip could fall into the case. I'd think it'd have to since it was in good condition and the bike's not blowing smoke or burning oil.

Would the fiche have details that my manual doesn't have?
I admit I'm a little rusty at this anymore. Looking at the piston Ryman posted the way it
comes in at the wristpin casting a clip could just drop straight down into the crank case.




Does someone have a 650 piston to measure the clip hole size? That does look small for a
650.
pluric is offline   Reply With Quote