ADVrider - View Single Post

MILLENNIUM FALCON · 05-03-2012, 08:17 PM

I got the motor bolted in the frame today. I just wanted to say thanks to my dad for coming over to give me a hand today. I went in pretty smoothly. A little pipe insulation and masking tape goes a long way for paint protection during installation. My fiberglass wrap came today. SO i figured I better get my pipes painted so I can wrap them tomorrow. I would like to install the exhaust while the engine cases are off, because it will give me much more room to slip them behind the frame. All the paint I have been using on the engine and exhaust it VHT flame proof ceramic 2000 degree paint. I also ordered my new rear rim today. I'm switching to a 2.15 the 1.85 was way to narrow for the tire.

05-03-2012, 08:17 PM	#89
MILLENNIUM FALCON ^OP Gnarly Adventurer Joined: Dec 2011 Oddometer: 191	I got the motor bolted in the frame today. I just wanted to say thanks to my dad for coming over to give me a hand today. I went in pretty smoothly. A little pipe insulation and masking tape goes a long way for paint protection during installation. My fiberglass wrap came today. SO i figured I better get my pipes painted so I can wrap them tomorrow. I would like to install the exhaust while the engine cases are off, because it will give me much more room to slip them behind the frame. All the paint I have been using on the engine and exhaust it VHT flame proof ceramic 2000 degree paint. I also ordered my new rear rim today. I'm switching to a 2.15 the 1.85 was way to narrow for the tire.