View Single Post
Old 05-07-2012, 03:24 PM   #27
rtwpaul OP
out riding...
rtwpaul's Avatar
Joined: Feb 2011
Location: round the world
Oddometer: 2,272
the bushings were out of stock and on back order, as the old ones were unusable i had to make new ones on the lathe in the shop where i work, the originals were made from 308 stainless which has a small amount of carbon hence the rust, i made the new ones from 316 S/S

yamaha paper weight

pull out the swing arm...that's it, about 15 minutes for it to be out, do some cleaning and regreasing if you haven't done it before, when you put it back in i use that rod to locate everything and check the side play and make the adjustment on the nut on the inside of the right frame rail to get it to spec

so do all steps in reverse to put it back together, this is the new one back in place with the new chain guard painted with an additional hole!!!

rtwpaul is offline   Reply With Quote