View Single Post
Old 05-08-2012, 05:22 AM   #242
Rich2wd
Gnarly Adventurer
 
Joined: Jul 2008
Location: Geraldton WA, Australia
Oddometer: 115
Quote:
Originally Posted by cjracer View Post
Great lookingg bike Rich, that 300 must be a blast.

The chain I use is the ONLY 420 o-ring chain I have found in the market.

EK 420SRO 132 link. If you need help getting on down under, let me know. I can send you one to try. These are all Clip link chains, but I've never had an issue. This should be good for you to get 2 chains, plus you'll need an extra Master Link.

Not 100% sure it will work on your bike, as I designed my chain housing to have a little more room from the start, knowing I wanted to go this direction. The guys at Christini said they still run and send the bikes out with Non-o-ring chains as the smaller engine would or could notice a HP drain using an O-ring chain. Every little bit helps.

I've run my 950 on the dyno with the front chain on, AWD disengaged. No HP loss was noticed to the rear wheel. Not that I'm concerned, there is plenty there to spin up BOTH wheels at will in the dirt.

Not sure how to embed this???

http://www.youtube.com/watch?v=gj9I2Ma_duM
Thanks CJ, I'll shoot you an email when I'm looking at getting a new chain.

Cheers Rich
__________________
Formerly Rich too_wheelz
2007 KTM 990 Adventure
2009 KTM 300 Christini AWD
Rich2wd is offline   Reply With Quote