Thread: My ADVersys
View Single Post
Old 05-15-2012, 09:28 AM   #21
kajj OP
Gnarly Adventurer
 
kajj's Avatar
 
Joined: Aug 2011
Location: In northern Sweden
Oddometer: 191
Quote:
Originally Posted by aiMhi View Post
Ha! Found you Anton and subscribed

Very creative using the plastic to close up the cowlings.
Looks like you are a hands-on guy unlike many of the others out there.


Post up a pic of what you are going to use for the headlight.
hehe. Thanks for checking out my build.

Will posts some updates in a couple of days when I hopefully have the new rear shock back from the workshop.

I will use one of the two round lights seen above mounted on the bike. Because one of them have both high beam, low beam and parking light and are approved for street use.
But i will need one more light to use together with the high beam.

I am thinking of a LED-light, but haven`t decided which one yet. Or how and where to mount it.
Maybe you have some ideas?

The diameter of the light is 10.8cm. So a hole with 11.3-11.5cm should be enough for allow some adjustment of the light.
Maybe you could check if there is room left on the fairing for one of your LED-lights?
I now I said I would skip them for now. But if there is room to mount one on the fairing then why wait.

I saw that you have to different lights on your website. One was more expensive then the other. Whats the difference between them? Will the shipping cost increase if I add one light?

It is ok to post pictures of the fairing whit the mock up for the light (lights?) in this thread if you want to.
kajj is offline   Reply With Quote