View Single Post
Old 05-17-2012, 06:19 AM   #84
dentvet OP
Beastly Adventurer
 
Joined: Aug 2008
Location: hunt country virginia
Oddometer: 1,282
The hub I have is a 26mm axle but the Thinja has a 20mm axle. I decided to make some sleeves that slide into the stock ktm spacers. These spacers took forever for a rookie without the proper tooling. I had to drill the blank with as large a bit as possible then I used a boring bar to get to 20mm. Whats the proper tool for this, 20mm drill bit or reamer? Oh well, i'm learning the hard way as usual.

dentvet is online now   Reply With Quote