View Single Post
Old 06-09-2012, 08:22 PM   #2333
boxermoose
Now fully goosed
 
boxermoose's Avatar
 
Joined: Sep 2003
Location: Gulf Coast TX
Oddometer: 2,844
Quote:
Originally Posted by Holeshot08 View Post
Hello,

Could someone weigh on on the seat height design? Today while riding with the seat high it dropped at a stop light, then I removed the seat and noticed the plastic lock bar towards the front of the seat on the underside was cracked all the way through. It is the part that the Toung from the tank area slides into, low or high slot. So does the front of the seat get its support from that device or the plastic blocks underneath? It seems like I now only have the low position...

Appreciate any assistance here.

Thanks Chuck
If it is a 2012 us model - the 4 rubber step blocks face the same way - either all with the high part forward or all with the high part facing backward - to set hi or low position

Far as I can see the seat has tongues under the tank and the rear seat provides the positive retention and the rubber step blocks are load bearing
__________________
Sometimes you get the ABAT....and sometimes the ABAT gets you
boxermoose is offline   Reply With Quote