View Single Post
Old 06-17-2012, 09:10 PM   #5281
scrambler66
Gnarly Adventurer
 
scrambler66's Avatar
 
Joined: Oct 2011
Location: Germany
Oddometer: 231
Quote:
Originally Posted by gforcephuket View Post
The master brake cylinder I have on there now is pretty good, especially with the braided lines and good pads, but I'd like to put on something even stronger -- can anyone recommend something that would work. I asked the guys at one shop if an XR 250 mbc would go on there but they weren't sure and said they'd actually have to get one and try it. Any advice about this would be appreciated.
The NX250 cylinder (and the XL350/600/NX650 and some XR600/650 models) got 11mm diameter (see below). The Xr250 master cylinder has 1/2 inch (12,7mm). At least the one I got. So if you take a xr master cylinder, pulling the brake lever will be harder in order to get the same brake power, but it will not improve it. Something that may work is an oversize kit from EBC. Since NX250 And XR600 share the same brake calipers, you can take a XR600 280mm brake disc http://www.jcmotors.com/p-29365-ebc-...x#.T96uooE-2Vk





Thats an example for an 1/2 inch master cylinder (Xl250 degree)


scrambler66 screwed with this post 06-17-2012 at 09:34 PM
scrambler66 is offline   Reply With Quote