View Single Post
Old 06-19-2012, 12:39 AM   #12652
Beastly Adventurer
jaumev's Avatar
Joined: Jun 2011
Location: Barcelona
Oddometer: 1,520
Skid plate crash test

Yesterday I did a short but intense crash test to the new ACD skid plate I'm helping to develop.
I hate to do it, every “clonk” it hurts to me but I don’t know another way to try it.....
The marks in the aluminum are evident but it did it's job.
Even so, we must modify quite a lot the original design: it’s too low and wide, it must be closer to the engine, needs a foam, must change the rear bolts, etc.
But considering is the first prototype was a good start

Crash test video:

Crash test

jaumev screwed with this post 07-02-2012 at 11:37 PM
jaumev is offline   Reply With Quote