View Single Post
Old 07-01-2012, 06:04 AM   #8
Beastly Adventurer
Joined: Oct 2006
Location: NW PA
Oddometer: 1,048
Originally Posted by kawzak View Post
I have a needle with a zerk on it. I need to get the regular fitting end on the zerk so I can pump lots into this u-joint. The other (2) took alot before it slightly oozed out around the seals.I dont think I can get enough in there with a needle.Thanks for the suggestion though.
I have been using a needle tip for mine and it works just fine.

The shortest distance between two points is boring.
Railbender is offline   Reply With Quote