Ural drive shaft U-joint -to grease
View Single Post
07-03-2012, 05:04 AM
Curmudgeon At Large
Joined: Jun 2005
Location: Same trailer, different park, FL
The early BMW's had a flat zerk fitting, no ball for the grease gun to clamp onto, just the spring loaded check ball in the middle that you pushed the needle tip into. Over the years I've used that needle for lots of tasks, greasing CV joint, etc.
Bob Weis 04 K12RS - Hannigan Hack
Everything happens for a reason, but sometimes the reason is you're stupid and make bad decisions.
View Public Profile
Find More Posts by Bobmws