View Single Post
Old 07-03-2012, 02:05 PM   #5
moto-treks OP
Back Home
moto-treks's Avatar
Joined: Dec 2007
Location: Spokane Washington
Oddometer: 1,808
Originally Posted by EatinDirt View Post
Your in way to deep now you can't stop and go back cuz I want those other filters....
Oh man don't I know it

I lengthened the wire for the Temp sensor about five inches and it fits great. Just hope adding the extra wire doesn't change the way the ECU reads the temperature.

After I had the connector installed I check the clearance with the secondary throttle. It didn't touch but was a little too close for me so I rotated the Temp Sensor 180 degrees in the base plate and now there is plenty of space between the connector and the secondary throttle arm.

This is how I ended up installing the Temp Sensor in the base plate.

Baseplate all ready to go - just need to add the filter

Moto Trek'n to New York via the Trans Labrador Hwy, South America


moto-treks screwed with this post 07-04-2012 at 04:18 PM
moto-treks is offline   Reply With Quote