Installing a CPR air filter on my 990
View Single Post
07-03-2012, 08:10 PM
Joined: Dec 2007
Location: Spokane Washington
And here it is all oiled up and installed
And all buttoned up - lots of room in there but I will need to take the top cover off to clean the filter
I didn't know if I needed to install a resistor in place of the SAS pump so for the first test I plugged the SAS pump in, hit the starter button and she fired right up
Next was to plug in TuneECU and switch the SAS off. After that I removed the SAS pump and again, she fired right up with no FI errors
Finally, since I'm guessing I'll be getting more air
I loaded the map for a 2011 R Akrapovic slip-on, did the 15 minute idle reset and I was ready for a test ride.
All I can say is
it has a lot more power over the whole RPM range.
Tomorrow I'm off for a custom tune
Moto Trek'n to
New York via the Trans Labrador Hwy
moto-treks screwed with this post 07-04-2012 at
View Public Profile
Visit moto-treks's homepage!
Find More Posts by moto-treks