View Single Post
Old 07-04-2012, 01:54 PM   #13
vetsurginc
Adventurer
 
vetsurginc's Avatar
 
Joined: Jan 2012
Location: Parkland, FL
Oddometer: 70
Quote:
Originally Posted by kawzak View Post
I have gone over everything on my new Patrol. The drive shaft u-joint grease zerk just don't have enough clearance to get a grease gun fitting on.I even machined the barrell/end of my grease gun fitting smaller dia. still no-go. Suggestions? or just take the drive shaft loose from rear hub. Not a big deal-just curious what others do.I even tried an old slender slide pump type gun for lubing milling machines. Angle is just too tight.
Harbor Freight Had a hand mini grease gun (3 ounce cartridge of grease) that fits my 2011 GearUp zerks very nicely. So snug a connection I've had to use a flat blade screw driver to help pop it off.
vetsurginc is offline   Reply With Quote