View Single Post
Old 07-19-2012, 06:13 PM   #5
weld86 OP
Weld86 Motoparts
 
Joined: Oct 2007
Location: Agua Dulce, CA
Oddometer: 190
Quote:
Originally Posted by Ogre_fl View Post
Not in the market for a skid plate (have one).

But if you develop that tool tube for the DR650 to fit a DRZ 400S I would be for it.
Thanks. I'm working on it. It would mean removing the charcoal cannister.

Quote:
Weld Done

May I suggest one extra hole to allow a socket to undo the shifter bolt.
That's a good idea. That will be done. Thanks.

weld86 screwed with this post 07-19-2012 at 06:21 PM
weld86 is offline   Reply With Quote