View Single Post
Old 08-01-2012, 03:26 AM   #18
Phreaky Phil
Beastly Adventurer
 
Joined: Mar 2006
Location: NEW ZEALAND
Oddometer: 1,722
Quote:
Originally Posted by Beater View Post
I have an interesting question ... but I have some DRZ400 forks (49mm) and was curious of the design for these triples. I was wondering if your offset was the BMW standard offset (20mm? 30mm?)?

I was also thinking that 49mm would be close enough to 50mm to work? Thoughts?

The DRZ400 triple is nice and beefy, but the offset is ~15mm (guess) and I am unable to make tight turns. Thanks in advance ....

Fred
Just a thought that the DRZ bottom triple is a gull wing design. On the DRZ, the sliders come within about 10mm of the bottom clamp when bottomed out, so the bottom clamp would need to be a gull wing type unless the bottom clamp sits higher in comparison to the DRZ bottom clamp. ( I have DRZ forks on my DR 650 and have looked at them for my airhead) They are a good fork. I think they would work well but some careful measuring / calculating would be needed with a non gull wing clamp.
Phreaky Phil is offline   Reply With Quote