View Single Post
Old 08-03-2012, 02:44 PM   #1573
kajj
Gnarly Adventurer
 
kajj's Avatar
 
Joined: Aug 2011
Location: In northern Sweden
Oddometer: 191
Quote:
Originally Posted by jdrocks View Post
brakes are fine with the OEM caliper, braided SS line, and either 290 or 310mm rotor. you might as well use a 310mm setup because you're going to fabricate a simple spacer/relocation bracket. i have a 4 piston caliper, but i feel the brakes are darn good without it. remember, you need a pair of rotors, because you're going to cut the center out of one for a hub block off plate on the right side.

late model DRZ400 uses the 20mm axle, same as the DL1000 wheel. the Versys and DRZ axles are the wrong length, so to make the correct size 20mm axle i used the Versys/ER6 swingarm bolt threaded and cut to length. these bolts can be found cheap.
ok, Thanks.
kajj is offline   Reply With Quote