View Single Post
Old 08-12-2012, 06:50 PM   #10
Maytag Repairman
Gnarly Adventurer
Maytag Repairman's Avatar
Joined: Jun 2010
Location: Kingston, Washington
Oddometer: 136
SW Motech Engine Guards

Here is my next project's obstacle. I bought the SW Motech engine guards. The instructions looked easy enough. First, remove a bolt on each side of the bike from the plastic cover(s) at the bottom front. Then on the right side of the bike remove a hose clamp. Next remove the bolt behind the hose. It looks like a hefty bugger. Took a 19mm socket to get on it if I remember correctly. There isn't much clearance between the wrench and the bike and it felt like it was on there pretty tight. I was afraid I might ding something on the side of the bike with the wrench if I had to really put my back into getting it off. It will have to wait until I pick up a socket extension for more clearance. Probably won't find the time to touch it again until Saturday.

Maytag Repairman screwed with this post 08-13-2012 at 12:54 PM
Maytag Repairman is offline   Reply With Quote