View Single Post
Old 08-12-2012, 09:35 PM   #6
Beastly Adventurer
Joined: Oct 2004
Location: Anchorage, formerly Spenard (hub of the universe)
Oddometer: 5,949
I assume you knew I was referring to riveted chain & not those with the snap in clip. one more thing.... the steel they use on the pins is quite hard & a file might not cut it too well. I use a cutoff wheel or 4" grinder. try your stuff on a bit of scrap, especially if you think you are going to use it on the road
Beezer is offline   Reply With Quote