View Single Post
Old 08-15-2012, 05:14 AM   #30110
Joe Watson
Beastly Adventurer
 
Joe Watson's Avatar
 
Joined: Jul 2008
Location: Sunshine Coast, Qld, Aus.
Oddometer: 1,028
Hey guys. No real step by step guide from me. I used these videos and it was easy as. I also referred to the manual as well while I was doing it just to make sure everything was right. I used no special tools at all. A couple of tips and tricks: instead of a "Seal bullet" you just wrap the area of the large bushing where the sharp lips are with electrical tape and just use heaps of lube on everything and it makes everything go back together so much easier. As for special tools, I already mentioned tape instead of seal bullet. I just used a screwdriver to get the inner bushing home (super super carefully and slowly to not touch the inner fork tube and rotating very regularly to make sure it all goes down level) then for the fork oil level, I just marked it out on a long screwdriver and kept adding oil until it touched the end of the screwdriver.



Joe Watson is offline   Reply With Quote